There are 8 wires on the plug.
Two pins connect to the track pickups:
· Red wire to right rail pickup (Pin #8).
· Black wire to the left rail pickup (Pin #4).
Please select from the following:
LY012- 5 Pack Decoder Harness with NMRA Plug
LY011-5 5 Pack Decoder Harness
LY012-5
Decoder Harness with NMRA plug
Designed for all decoders that support the 9 pin industry standard decoder socket.
Each Harness contains an NMRA medium 8 pin plug
Install one decoder harness in each locomotive.
Allows you to share a decoder between multiple locomotives.
Package includes harnesses for 5 locomotives.
| Wiring Color Code There are 8 wires on the plug. Two pins connect to the track pickups:
|
|
Two pins connect to the motor terminals:
· Orange wire to the motor terminal that was previously connected to the right rail (Pin #1).
· Gray wire to the motor terminal that was previously connected to the left rail (Pin #5).
Three pins are for the headlights:
· White wire to the forward headlight (Pin #6).
· Yellow wire to the rear headlight (Pin #2).
· blue wire to the headlight positive common (Pin #7).
One pin is for the first extra function:
· Green wire connects to auxiliary function1 (Pin # 3).
One wire is for a second extra function:
· Violet wire connect to auxiliary function2.
Once installed in the locomotive the DH Decoder Harness can be plugged into any 9 pin equipped decoder.
Place the locomotive (without the body) on the programming track and read back the locomotive address from the decoder. If the decoder is properly installed, you will be able to read back the factory pre-set address 03. Remove the locomotive from the track, and if necessary correct any wiring errors.
Designed for all decoders that support the 9 pin industry standard decoder socket.
Install one decoder harness in each locomotive.
Allows you to share a decoder between multiple locomotives.
Package includes harnesses for 5 locomotives.
| Step by Step Installation Connect the LY011 harness to the track pickups:
Connect the decoder to the motor terminals: |
|
Now connect the headlights:
If the light bulbs are isolated from the rails, connect the blue wire to the other bulb terminals (pin 7).
Two wires are for extra functions:
Once installed in the locomotive the DH Decoder Harness can be plugged into any 9 pin equipped decoder.
Place the locomotive (without the body) on the programming track and read back the locomotive address from the decoder. If the decoder is properly installed, you will be able to read back the factory pre-set address 03. Remove the locomotive from the track, and if necessary correct any wiring errors.
Copyright 2009 by Lenz Elektronik, GmbH. All Rights Reserved
This page was designed by Debbie Ames, owner tttrains
(Pin location shown if
logotype has sockets or you are using an NMRA
plug