LE075
NMRA DCC Decoder
World's smallest DCC
decoder suitable for Z and larger scales now comes in an improved
version based on the proven LDE 33 chip. The decoder sports 14/27
speed steps and directional headlight control. The decoder is
rated at a continuous current draw of 1/2 Amp. The LE075 is
compatible with all DCC systems currently on the market. The two
part construction allows this decoder to be tucked away into most
N-Scale locomotives and many Z-Scale locomotives without removing
massive amounts of locomotive weight.
Specifications:
- Suitable for permanent magnet motors to 1/2 Amp.
- Uses the popular LDE-33 microprocessor.
- Fully compatible with all Digital command control systems
operating to the NMRA Standard and RP's.
- One Cab controlled directional function (may be used for
direction dependent headlight control).
- Electronically programmable: 110 addresses.
- Able to operate on conventional DC power packs. (requires
extra capacitors for some pulsed power packs)
- Safe handling: no anti-static work station needed
Dimensions:
L .63" x W .44 " x H.145" , L15,5 x B11,4 x
H3,6mm (receiver part)
L .41" x W .325" x H.11" , L10,5 x B 7,6 x H2,6
mm (rectifier part)
Important note for
Locomotive Decoder LE075
The assignment of wire colors for LE075
has now been aligned with the new NMRA-DCC/NEM standards.
Therefore the wire color assignment is now also identical with
all other DIGITAL plus Locomotive Decoders. In the following
table the colors for the wires of the older LE075 and the colors
for the wires in the new LE075 are cross-referenced. Note that if
the decoder has a brown wire the decoder is of the older style
while if the decoder has a gray wire it is of the newer style.
When installing an LE075, please be careful to check to ensure
which version you have as improperly installed wires could result
in damaging the decoder.
| Old
color |
New
color |
Remarks
|
| black |
orange
|
motor
|
| red
|
gray
|
motor
|
| blue
|
black
|
track
|
| white
|
red
|
track
|
| brown
|
white
|
light front
|
| yellow
|
yellow
|
light rear
|
| orange
|
blue
|
connection chip
- rectifier |
Before installation, check to see which
decoder version you have in front of you. You can most easily
determine this based on the wire color used for the connection
chip ñ rectifier. Incorrect installation will lead to the
destruction of the decoder!
CVs Supported:
The LE075 only supports 4 CVs which are programmable using any
DCC Command Station that supports Register or Paged Mode.
- CV 1 Address 1-111
- CV 2 Starting Voltage 1-15
- CV 3 Acceleration 1-15
- CV 4 Deceleration 1-15
Copyright 1995-2001 by Lenz Elektronik, GmbH. All Rights
Reserved
This page was designed by Debbie
Ames, owner tttrains
World's smallest DCC
decoder suitable for Z and larger scales now comes in an improved
version based on the proven LDE 33 chip. The decoder sports 14/27
speed steps and directional headlight control. The decoder is
rated at a continuous current draw of 1/2 Amp. The LE075 is
compatible with all DCC systems currently on the market. The two
part construction allows this decoder to be tucked away into most
N-Scale locomotives and many Z-Scale locomotives without removing
massive amounts of locomotive weight.