LE230 V5.1
NMRA DCC Decoder
For Large Scale
The LE230 decoders are fully programmable in Register, Direct and Paged programming.
This allows for full programming with any NMRA DCC compatible Command Station or
Programmer. This gives owners of these systems full access to these outstanding decoders
from Lenz.
- Control of the motor's rotational speed (load compensation). Regardless of the load, the
motor's rotational speed is kept nearly constant. During extremely slow movement (For
instance through sharp curves and over a series of turnouts), the LE230 always provides
the motor with enough voltage.
- Selectable for operation with 14/27 or 28/55 speed steps.
- Operation on conventional DC layouts. This feature may be disabled.
- Provides 2.5 A continuous motor current.
- Eight switchable function outputs (includes two for directional lighting) that can be
connected directly or through Function Module LF200 (depending upon the current draw) and
two additional function outpouts controllable through the LP200 auxillary motor module.
- Support for Advanced Consist Control and Extended addressing.
- Support for short form programming on the main for acceleration and deceleration trim.
- Support for all forms of programming as described in NMRA RP- 2.3.
- Programmable locomotive address, acceleration, and brake momentum, speed curve, and much
more.
Size: L 2.75" x W 1.20" x H.35"
L 70.0 x W 30.0 H 12. mm
Warranty
Complete LE230 Manual in PDF Format
Copyright 2001 by Lenz Elektronik, GmbH. All Rights Reserved
This page was designed by Debbie Ames, owner tttrains